SFC Energy EFOY GO Mode D'emploi page 40

LED
No.
display
3
4
5
9
*To read off the internal error code, press the (grey) Power ON / OFF button on the
right for more than ten seconds and count how often the LEDs light up. This number
indicates the internal error code. Pass the internal error code on to the SFC service
engineer.
Page 40
Problem Description
Battery The temperature of
temperature the EFOY GO! is too
high / too low.
12 V The load on the 12 V
connection connection is too high
overload / or a short circuit has
short circuit occurred.
230 V The load on the 230 V
connection connection is too high
overload / or a short circuit has
short circuit occurred.
Internal An internal error has
error* occurred.
Faults and remedies
Solution
Wait until the EFOY
GO! has cooled down
/ warmed up. Then
switch the EFOY GO!
back on.
Disconnect the load
from the 12 V
connection and
switch the EFOY GO!
back on. Please
check the current
consumption of your
load (I < 10 A).
Disconnect the load
from the 230 V
connection and
switch the EFOY GO!
back on. Please
check the power
consumption of your
load (P < 400 W).
Switch the EFOY GO!
back on. If the error
occurs again, please
contact the EFOY
Hotline. You will find
contact details in
chapter 1.2 "Service
contact" on page 23.