Flight Operation; Trimming The Helicopter; Troubleshooting - Carson Easy Tyrann 370 Mode D'emploi

FLIgHt operatIon

trimming the helicopter

Already shortly before the Helicopter takes off, you can recognize
whether it wants to turn or glide in a particular direction. Correct
the deviations from the vertical ascent with the trim knob of the
turn function.
tip of the fuselage turns to the right:
• Reduce speed and push the trim slider of the turn function on
the left remote control lever stepwise to the left.
• Push the pitch-lever forward again and check whether the
correction was sufficient, if necessary shift the trim further to
the left.
• Repeat the process until the Helicopter no longer shows a
tendency to turn to the right.

troubLeSHootIng

problem
the model does not move
Motor does not turn
the model reacts incorrectly to the con-
trol commands or flies choppily
the model does not take off
the model moves forward/ backward and
sidewise, but does not hover
the model vibrates severely
transmitter and Helicopter can not be
binded
Can not take off
Blade A
GB // 26
tip of the fuselage turns to the left:
• Proceed as described above, but push the trim slider of the turn
function stepwise to the right.
Cause
Check, if the transmitter and the model are
switched ON.
Check the battery voltage of transmitter
and model
Motor is defective
Motor is too hot
Check the state of the transmitter and
receiver battery charges
Rotor blades are twisted
Motor is too hot
Batteries are empty
Check whether the Helicopter is exposed to
a draught, e.g. by an opened window or an
air conditioner. Hover flight is not possible
when there is a draught
Check whether the rotors run true
Throttle control not set to minimum
Wrong installation on rotors
Reparation
Switch on the Transmitter and the Model.
Employ completely charged batteries
Exchange the motor
Allow the motor to cool down
Employ completely charged batteries
Exchange the rotor blades
Allow the motor to cool down
Charge the batteries or exchange them
Close the window/door, switch off the air
conditioner or select a more suitable room
Possibly change the rotor blades
Throttle need to be minimized to zero
Mount the propeller as shown below
Blade B