Thrustmaster T248 Mode D'emploi page 28

Adjusting the SPACING of the three pedals
- Using the included 2.5 mm Allen key (3), unscrew the two screws holding the metal head (12) and
its support (11) in place.
- Select your preferred position (to the left, centered, or to the right), then replace and re-tighten the
screws so that the metal head (12) and its support (11) are held firmly in place.
Left position
Adjusting the INCLINATION of the pedals
- Using the included 2.5 mm Allen key (3), unscrew the two screws holding the metal head (12) and
its support (11) in place.
- Turn the plastic head support (11) 180°, then replace and re-tighten the screws so that the metal
head (12) and its support (11) are held firmly in place.
Less inclined position (default)
Number of possible inclination positions per pedal:
Examples illustrating the brake pedal:
Centered position
(default)
Number of possible spacing positions per pedal:
- Three for gas pedal
- Three for brake pedal
- Three for clutch pedal
Examples illustrating the gas pedal:
- Two for gas pedal
- Two for brake pedal
- Two for clutch pedal
27/32
Right position
More inclined position