Thrustmaster T248 Mode D'emploi page 15

MAPPING FOR PC
USING THE E1 / E2 / E3 / E4 ENCODERS
You can select the active encoder by pushing the encoder selector switch (4) up. The active
encoder is displayed on the screen: E1, E2, E3, E4 in succession, and then E1... and so on again.
When the encoder (E1, E2, E3 or E4) is selected, the associated functions are as follows:
- Push (P) by pushing the encoder selector switch (4) down.
- + by pushing the encoder selector switch on the right-hand side (5) up.
- - by pushing the encoder selector switch on the right-hand side (5) down.
The corresponding action is displayed on the screen.
Please note:
- The E1, E2, E3 and E4 encoders function in most games.
- The screen displaying telemetry information functions in games compatible with the Thrustmaster SDK.
The list of compatible games is available here: https://support.thrustmaster.com (in the Racing
Wheels / T248 / Games Settings section). This list is updated regularly.
14/32