Assembly; Adjust The Handle Bar; Add Oil To Engine; Fill The Fuel Tank - Echo WT-1610T Manuel De L'opérateur

Masquer les pouces Voir aussi pour WT-1610T:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2

ASSEMBLY

Section

2.1 ADJUST THE HANDLE BAR

1. Open shipping box and remove packing material.
2. Loosen T-handles on handle bar. Raise upper portion
of handle bar to desired position. Tighten T-handles.
3. Cut the two corners of the shipping box so that the
4. Install recoil rope into recoil loop on handlebar.
5. Rotate recoil loop to make contact with handle bar
and capture recoil rope.

2.2 ADD OIL TO ENGINE

owner's manual.
4

2.3 FILL THE FUEL TANK

since spilled fuel could ignite if it comes in contact
with hot parts or sparks from ignition. Do not start the
engine near spilled fuel. Never use fuel as a cleaning
agent.
DO NOT MIX OIL WITH FUEL.
Use only those types of fuels that are recommended in
your engine owner's manual.
To add fuel:
1. Stop engine, wait for all parts to stop moving and
disconnect spark plug wire. Allow the engine and
2.
3.
up any spilled gasoline.
WHEELED TRIMMER
WARNING
Gasoline and diesel fuels are highly
property damage:
Store fuel only in approved containers,
in well ventilated, unoccupied buildings,
with a capacity of 2 gallons or less with
a pouring spout is recommended. Do

Publicité

Table des Matières
loading

Table des Matières