VANTRUE Element 1 Mode D'emploi page 12

Note: There are two protective films numbered 1 and 2. Please remove
the protective film from No. 1, paste the electrostatic sticker on the
windshield, and then remove the protective film from No.2.
EN EN
3. Remove the 3M tape from the mount, then fix the mount and camera
EN EN
on the electrostatics stickers.
4. Connect the car charger to the car cigarette lighter, then insert the
USB end of the charger into the Type C USB power port of the camera.
After the car is started, the camera can be powered on immediately.
- 8 -