Grinder Safety Warnings - Makita 9561CH Manuel D'instructions

ENGLISH
(Original instructions)
1 Shaft lock
2 Slide switch
3 Speed adjusting dial
4 Wheel guard
5 Bearing box
6 Screw
7 Lever
8 Lock nut
9 Depressed center grinding
wheel/Multi-disc
SPECIFICATIONS
Model
Depressed center wheel diameter
Max. wheel thickness
Spindle thread
Rated speed (n) / No load speed (n
Overall length
Net weight
Safety class
Model
Depressed center wheel diameter
Max. wheel thickness
Spindle thread
Rated speed (n) / No load speed (n
Overall length
Net weight
Safety class
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Explanation of general view
10 Inner flange
11 Lock nut wrench
12 Abrasive disc
13 Rubber pad
14 Marking A
15 Marking B
16 Marking C
17 Pin
18 Vent
9561CH 9562CH
115 mm 125 mm
6.4 mm 6.4 mm
M14 M14
)
0
289 mm
2.2 kg 2.2 kg
9561CVH 9562CVH
115 mm 125 mm
6.4 mm 6.4 mm
M14 M14
)
0
289 mm
2.2 kg 2.3 kg
ENE048-1
ENF002-2
19 Wire cup brush/Wire bevel
20 Abrasive cut-off wheel/diamond
21 Wheel guard for abrasive cut-off
22 Exhaust vent
23 Inhalation vent
9563C
100 mm
6.4 mm
M10
–1
12,000 min
2.1 kg
/II
9564CV
115 mm
6.4 mm
M14
–1
12,000 min
299 mm
2.3 kg
/II
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future refer-
ence.

GRINDER SAFETY WARNINGS

Safety Warnings Common for Grinding, Sanding,
Wire Brushing, or Abrasive Cutting-Off Operations:
1. This power tool is intended to function as a
grinder, sander, wire brush or cut-off tool. Read
all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
brush
wheel
wheel/diamond wheel
9564C 9565C
115 mm 125 mm
6.4 mm 6.4 mm
M14 M14
299 mm
2.3 kg 2.3 kg
9565CV
125 mm
6.4 mm
M14
2.4 kg
GEA010-1
GEB033-8
5