Work Safety - Husqvarna DM 406 H Manuel D'utilisation

Work safety

• The machine has a very high torque. This demands good
concentration during work, as serious personal injuries
can occur if the drill bit suddenly jams.
• Keep your hands at a safe distance from the drill spindle
and drill bit when the machine is running.
• Keep an eye open for oil or water leakage. If water or oil
trickles out from the leakage hole on the top of the pinion
neck, the seals must be replaced.
Stand drilling
• The machine is intended for stand mounted drilling.
• Make sure that the stand is secured correctly.
• Make sure that the drilling machine is secured correctly in
the stand.
• Take extra care during the start of the drilling when the drill
bit is placed against the work piece. The drill bit does not
have any guidance. This increases the risk for it starting to
drift. This puts load onto the stand, with the risk of its
fixing breaking loose.
• Be careful if the drill bit gets caught in the work piece. This
puts load onto the stand, with the risk of its fixing breaking
loose. This will cause the stand to start rotating around the
drill bit.
• Make sure that the cooling water does not come into
contact with an electrical cabinet or similar.
8 –
English
SAFETY INSTRUCTIONS