hergom ECLECSYS Serie Instructions Pour L'installation, L'utilisation Et L'entretien page 21

3.3.– CHANGING THE TOP SMOKE OUTLET FOR THE
REAR OUTLET ON DEVA II 100, ECLECSYS II 100
AND PAS II 100 MODELS.
The cooker is supplied with the smoke outlet ring insta-
lled on the upper outlet.
In order to change the ring from the top to the back
outlet:
1. Release the four screws that attach it to the hob,
2. Remove the cover on the back outlet unscrewing the
4 screws
3. Place the ring on the back outlet and the cover on
the top outlet.
See picture 19.
3.4.– CHIMNEY SEALED ACCESS SYSTEM
The COOKER has an access system to the chimney, in
order to make it easier to seal it, once has been installed,
as well as its cleaning when necessary. To access it, pro-
ceed as follows:
1. Remove the vitroceramic worktop from the Cook-
er and the cast iron under-worktop (figures 20 and
21). If your cooker model has a top outlet, remove
the glass-ceramic or pulifer worktop and the sup-
plement with collar, unscrewing the two screws of
the worktop supplement to the flue collar access
support. If your cooker model has a cast-iron
FIG. 19
worktop with washers, lift the worktop to access
the flue collar, but remember that it is a very
heavy worktop, so please handle it with auxiliary
means, taking extra care not to damage it during
handling.
2. Dismantle the draught rod (figure 22).
3. The access cover to the chimney is removed to-
gether with the draught valve upwards (figure 23).
19
20
21
FIG. 22
FIG. 23