Hobbytech 4WD CRX 18 FLAT CAGE Notice D'utilisation page 2

PRECAUTIONS
IMPORTANT - READ THIS BEFORE RUNNING
PLEASE READ ALL INSTRUCTIONS AND FAMI LIARIZE YO URSELF WITH THE PROD UCTS AND
CONTRO L BEFORE OPERATION .
This product is not a toy. It is a high performance model product. It is important to familiarize yourself with the model, its
manual, and its construction before assembly and operation. Adult supervision is necessary
CAUTION
To avoid serious personal injury and property damage, operate all remotely controlled models in a responsive manner as
outlined below.
R/C car models can exceed speeds of 40km/h (25mph), and cannot be stopped quickly.
❶ Never run R/C models on the street or highways, as it could cause or contribute to serious traffic accidents.
❷ Never run an R/C model near people or animals, nor use people or animals as obstacles when operation R/C vehicles.
❸ To avoid injury to persons or animals, and damage to property, never run a R/C model in a confined or crowed area.
❹ Running R/C models into furniture or other inanimate objects will cause damage to the objects and the R/C models.
CAUTION DURING OPERATIONS
When the R/C model is in operation, dot not touch any of its moving parts, such as drive shafts, wheels, as the rotating parts
can cause serious injury.
❶ The vehicle motor gets very hot during running and could cause burns if touched.
❷ Make sure that no one else is using the same frequency as yours in your running area. Using the same frequency at the
same time, whether is driving, flying or sailing, can cause loss of control of the R/C models, resulting in serious accidents.
❸ Properly connect plugs. To prevent electrical shock and/or damage to the product resulting from a short-circuit; insulate
connections with heat shrink tubing or electrical tape. Before running vehicle, check that battery wiring and plugs are not so
loose as to drag on the ground. Properly secure cables using electrical tape or nylon tie-wraps.
❹ Stiff rotation of gears, shafts, joints and wheels can burn out the motor. It's recommended to check proper joint and shaft
rotation by using one 1,5V dry cell during assembly of the model.
A worn motor will overheat and result in a short running time. Replace a worn out motor as soon as possible.
❺R/C models will run out of control when either the receiver or transmitter battery voltage drops off. Stop the vehicle
immediately when the car starts to show down to prevent it from running out of control.
• Hereby, [ Flysky Technology co., ltd ] declares that the Radio Equipment [FS-MG41] is in compliance with RED 2014/53/EU.
• The full text of the EU DoC and Appendix 1 of the FCC Statement are available at the following internet address: www.flysky-
cn.com
• Always keep the battery away from flammable objects.
• Never disassemble or modify pack wiring in any way or puncture cells.
• Never exceed the maximum of discharge rate or load.
• May explode if damaged or diposed of in fire.
• Store long term at 3.8V per cell. Avoid unnecessary charge cycling.
• Disclaimer: you declare that you have read and understood the safety instruction
before use and you agree to take the full responsability of results caused by
DECLARATION OF
improper use.
CONFORMITY
2