Table Des Matières; Assembly; Operational Information; Operation - DeWalt DXH330 Guide D'utilisation

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!

Assembly

• Remove the heater and all of the packaging material from the box.
• Check all of the packing material for loose parts and set aside.
• Remove and retain the four handle mounting screws that are threaded into the
top shell.
• Throughly inspect the heater for damage. If any is found do not contact the place
of purchase. Please call the Manufacturer at 855-805-5745.
• Use the four handle mounting screws to fasten the handle to the top of the
heater
Note: Do not over tighten the screws as they can crack the handle.
The handle is located in the carton loose be sure not to throw out.

Operational Information

The DeWalt Electric forced air heaters are designed to be used by professionals.
Heat is created by electric current passing through coiled metal elements bringing them up to very high temperatures. The fan then passes room air over the hot elements
exchanging cold air for warm.
The air moving over the coils keeps them from reaching temperatures that are not safe for the normal operation of the heater. However it is important to keep all combustible
materials and any objects that may be sucked into the fan blades at a safe distance (please refer to the table on the next page for appropriate distances). Make sure that the
fan blades remain unobstructed at all times.
Keep unit clean and dust free. Do not block unit intake or exhaust at any time.

Operation

Review and understand all warnings in this manual. Follow all local codes. These heaters are designed to be used with 240v ac only.
This heater must be wired by a certified electrician.
CONTENTS
WARNINGS ............................................................................ 2
ASSEMBLY ............................................................................. 3
OPERATION ........................................................................ 3-4
SPECIFICATIONS ................................................................... 4
CLEARANCES ........................................................................ 4
MAINTENANCE ...................................................................... 4
TROUBLESHOOTING ............................................................ 5
WIRING DIAGRAMS ............................................................... 6
PARTS LISTS/EXPLODED VIEWS...................................... 7-10
WARRANTY ......................................................................... 11
INSTRUCTIONS FOR ORDERING PARTS ............................ 11
3