Cleaning The Drain Pump Filter; Troubleshooting Guide - Saba LFS914GZ17EW Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cleaning the drain pump filter

1. Disconnect the
2. Place a container under
machine from the mains
the pump Unscrew and
electricity supply and
remove the filter.
open the lower cover
with a screwdriver.
GB
Note:The filter should be cleaned every 2 months or so,
or when there is fault that the "E03" is on the screen.
Important:
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Unhook the drain hose from the rear support and position
the end of this hose and that of the inlet hose in a bowl. Run
the spin programme.
4. Disconnect the appliance.
5. Screw the inlet hose and reposition the drain hose.
6. When you intend to start the machine up again, make sure
that the room temperature is above 0°C.
72
3. Clean the filter care-
fully.

Troubleshooting guide

Problem
Error Code
Possible Cause
The machine
"E01" is on the
1. The water tap is
fills overtime.
screen.
not open.
2. The drain hose is
put down.
3. The water inlet
valve is damaged.
There is a
"E02" is on the
1. The door is not
Door lock
screen.
locked well.
alarm.
2. Garment is caught
between the door
and the seal.
3. The door lock is
damaged.
The machine
"E03" is on the
1. The drain hose is
drains over-
screen.
squashed or kinked.
time.
2. The drain pump
filter is block.
3. The drainage
system pipes are
blocked.
Water over-
"E04" is on the
1. The water inlet
flows the
screen.
valve is damaged.
machine. /
2. The connection
Water sensor
between the water
works abnor-
sensor and wire is not
mal.
secure.
3. The water sensor is
damaged.
Solutions
1. Open the
water tap.
2. Hook up the
hose.
3. Change the
water inlet
valve.
1. Lock the door
GB
well.
2. Put the gar-
ment into the
drum.
3. Change the
door lock.
1. Check the
drain hose.
2. Clean the
filter.
3. Check the
drainage system
and clean it.
1. Change the
water inlet.
2. Check the
connection
and ensure it is
secure.
3. Change the
water sensor.
73

Publicité

Table des Matières
loading

Table des Matières