Level Adjustment; Drain Hose Connection - Saba LFS914GZ17EW Mode D'emploi

Keep the transit bolts for future trans-
portation. Whenever the machine is
transported, the transit bolts must be
refitted.
Installation place requirement
• A concrete floor is the most suitable
installation surface for a washing
machine, being far less prone to
vibration during the spin cycle than
GB
wooden floorboards or a carpeted
surface.
• The machine must be level and
securely positioned. The distance between the machine and
wall must be more than 10 cm.
• To avoid vibrations during spinning, the machine should not
be installed on soft floor coverings.

Level adjustment

The machine must stand
perfectly level on all four
feet to ensure safe and
proper operation.
Incorrect installation may
increase electricity and water
consumption and may cause
the machine to move about.
52
Transit bolt
Locknuts
Loose
Locked
High
Low
Adjustable feet
To do these when the machine is not level:
• Using the spanner turn locknut in a clockwise direction. Then
turn locknuts together with adjust feet to unscrew.
• Use a spirit level to check the machine is standing level.
• Hold adjust feet securely with a pipe wrench. Turn locknut
again using the spanner until it sits firmly up against the
housing.
Note: Vibration and noise may occur if the locknuts do
not sit firmly up against the houses.

Drain hose connection

1. Direct into a sink
If the outlet spigot has not been used before, remove any blank-
ing plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if re-
quired, ensure a loop is formed in the drain hose to prevent waste
from the sink entering the washing machine.
If required, the drain hose can be extended to a length of 4 m.
Loop
53
GB