Saba LFS914GZ17EW Mode D'emploi page 29

2. Connected securely to a standpipe.
Firstly form a hook in the end of the drain hose using the "U"
piece" supplied.
Place the drain hose into your standpipe, which should have an
internal diameter of approximately 38mm thus ensuring there is
an air break between the drain hose and standpipe.
When discharging into a standpipe ensure that the top of the
standpipe is no more than 90cm and no less than 60cm above
floor level.
GB
"U" piece
supplied
Water inlet connection
Connect the inlet hose supplied with the machine to a tap with a
3/4" thread.
Do not use previously employed hoses.
Installation should comply with local water authority and build-
ing regulations' requirements.
54
When there is an inlet valve at the back of the machine, it must
be connected to a cold water supply. If there are two inlet valves,
one is connected to a cold water supply and the other is con-
nected to a hot water supply. Follow the indication of the picture
below to complete the connection.
inlet valve for cold water
inlet hose for cold water
with a white nut
GB
55