Functional Description; Status Led; Movement Buttons Up, Stop, Down; Channel/Group Selection Button - Selve commeo Multi Send BASIS Notice

General section (BASIS and PREMIUM)

12. Functional description

12.1. Status LED

The status LED illuminates green to indicate an outgoing radio signal. In the event of a mes-
sage, the status LED changes from green to red after a certain period. The LED illuminates
orange if there is no receiver yet assigned to the selected channel.

12.2. Movement buttons UP, STOP, DOWN

Use the movement buttons (up = , down = ) during operation to move the respective
drives and receivers assigned to the selected channel or group.
Note: If controlling an awning, UP ( ) retracts the awning and DOWN ( ) extends it.
If the commeo Multi Send is in a menu item, you can select it using the buttons.

12.3. Channel/group selection button

Use the channel/group selection button to select the individual channels and groups.
Note: The movement commands in the central group switches all drives and receivers
assigned in the commeo Multi Send.

12.4. AUTO/MAN switching

In the "Automatic" (AUTO) position, the commeo Multi Send transmits automatic and manual
movement commands. In the "Manual" (MAN) position, the commeo Multi Send transmits
only manual movement commands (UP, STOP, DOWN by pressing the button).

12.5. Opening the menu

Open the main menu by pressing the left display button. Selection and the settings are
described in the "Programming" section.
Press and hold the left display button to activate the sensor visualisation and display the cur-
rent sensor values (wind, sun, etc.). This requires the sensor visualisation to be activated in
the menu.

12.6. SELECT/PROG. buttons

Use the SELECT and PROG. buttons on the rear side of the commeo Multi Send to assign and
adjust the individual drives and receivers. Please refer to the operating instructions of the
respective drive or receiver for precise instructions on how to do this.
90