Assembly of the Grill
1. Attach the 4 rubber feet (8) to appliance (rear side).
2. Attach the windshield (1) by inserting the prongs into
the respective openings of the housing (2). Make sure to
properly secure it.
3. Place the removable aluminium reflector tray (3) into the
barbeque enclosure (housing) (2).
4. Fasten the aluminium reflector tray (3) with the screw and
nut (11). the drilling holes are at the front, on the left of the
operating control.
5. Insert the two prongs of the operating control (5) into the
drilling holes of the appliance housing (2). Make sure when
30