T-Fal POWERGLIDE Anti-Calc Mode D'emploi page 6

• Warning ! The voltage of your electrical installation must correspond to that of
the iron (120V or 127 V). Connecting to the wrong voltage may cause irreversible
damage to the iron and will terminate the guarantee.
• If it is absolutely essential to use an extension cable, choose a 15 amp cord.
• If the electrical cord becomes damaged, it must be immediately replaced by an
Approved Service Centre to avoid any danger.
• The appliance should not be used if it has fallen, if it has obvious damage, if it leaks
or functions incorrectly. Never dismantle your appliance : have it inspected by an
Approved Service Centre, to avoid any danger.
• Never immerse your iron in water !
• Do not unplug your appliance by pulling on the cord. Always unplug your appliance:
before filling or rinsing the water tank, before cleaning it, after each use.
• Never leave the appliance unattended when it is connected to the mains. Before
storing the appliance, once it is unplugged, please wait until it has cooled down
(around 1 hour).
• Your appliance gives off steam, which may cause burns. Take extra care especially
when you are ironing close to the edge or on a corner of your ironing board. Never
direct the steam towards people or animals.
• Your iron should be used and placed on a flat, stable, heat-resistant surface. When
you put your iron onto its iron rest, make sure that the surface on which you put it
is stable.
• This product has been designed for domestic and indoor use only. The
manufacturer will accept no responsibility and the guarantee will be terminated, if
this product is used for commercial purposes, inappropriate use or failure to comply
with the instructions.
Environment protection first !
Your appliance contains valuable materials which can be recovered or
recycled.
Leave it at a local civic waste collection point.
6