Programming Mode - Roco CV29 Manuel D'utilisation

Only place the carriage on the track!
Programme the value 2 at CV61 (see programming mode)
Function
key
1 address function
st
1 address f1
st
1 address f2
st
1 address f3*
st
1 address f4*
st
2 address
nd

Programming mode

Note: programming is only possible if DIP switch #2 on the back of the Märklin
Programming:
1. set the speed controller to '0'
2. press stop+go for approx. 1 sec. in order to trigger reset (or disconnect/connect the Station)
3. press stop
4. enter the address or '80'
5. press go during the activation of the change in the direction of travel
6. enter the CV at Märklin
7. activate the change in the direction of travel
8. enter the value in two figures (1-79 possible, enter '80' for value 0)
9. activate the change in the direction of travel
10. the decoder has been programmed and is in travel mode
8045868921.indd 21
Function
Carriage tail light and
interior lighting
Carriage doors corridor side
Carriage doors
compartment side
Conductor's whistle
Conductor's announcement
in german language
no functions
6021 in two figures in the form of a locomotive address (CV1-79 possible)
1)
Function Type Direction-
related
ON/OFF

OPEN/CLOSE
OPEN/CLOSE
ON/OFF
ON/OFF
6021 has been activated.
1)
Additional
sound
GB



21
01.02.2010 13:51:38