Armani Exchange VX36 Instructions page 7

DIGITAL UPCR-992A
Time Mode
1 . Press B to change modes .
2 . Press A for EL .
3 . Press C to select 12/24 hour format .
4 . Press D to enable/disable hourly chime .
Time Setting
1 . In time mode, press and hold A for 2 seconds to enter time setting .
2 . Press C to increase setting value . Press D to decrease setting value .
3 . Press B to enter next setting field .
4 . Press pusher A to exit setting mode .
Alarm Mode
1 . Press B to enter alarm mode .
2 . Press A for EL .
3 . Press C to select alarm 1 or alarm 2 .
4 . Press D to enable/disable alarm .
12
Alarm Setting
1 . Press and hold A for 2 seconds to enter alarm setting .
2 . Press C to increase setting value . Press D to decrease setting value .
3 . Press B to enter next setting field .
4 . Repeat steps 2 and 3 until desired time is selected .
5 . Press A to exit setting mode .
NOTE: Alarm turns on automatically when exiting setting mode.
Chrono Mode
1 . Press B to enter chrono mode .
2 . Press C to start chrono .
3 . Press D to stop chrono .
4 . Press and hold D for 2 seconds to reset chrono .
NOTE: Maximum chrono time is 23 hours, 59 minutes and 59 seconds. When chrono
reaches maximum time, it will stop running. Press and hold D to reset value to
run chrono. 1/00s resolution for first 59 minutes and 59.99 seconds.
13