Publicité
PROGRAMMING TRACK NUMBERS
You can store up to 50 tracks to play in a
program. A single track may be stored more
than once in the program.
1 While playback is stopped, select a
track with ∞ or §.
2 Press PROGRAM/SHOOT/SELECT to
store the track.
➜ prog and the number of stored
tracks are displayed.
3 Select and store all desired tracks in
this way.
4 Press 2; to start playback of your
selected tracks.
➜ prog is shown and playback starts.
• You can review the program by pressing
PROGRAM/SHOOT/SELECT for more
than 3 seconds.
➜ The display shows all the stored
tracks in sequence.
Note:
–
If you try to store more than 50 tracks, FULL is displayed.
Clearing the program
• While playback is stopped, press 9 to clear program.
➜ Program Clear is displayed once, prog goes off, and the
program is cleared.
Note:
–
The program will also be cleared if the power supply is interrupted, or if the
CD-player lid is opened, or if the set switches off automatically.
RESUME AND HOLD
Storing the last position played – RESUME
You can store the last position played. When
restarting, playback will continue from where
you have stopped.
1 Switch the slider to RESUME during
playback to activate RESUME.
➜ resume is shown.
2 Press 9 whenever you want to stop
playback.
3 Press 2; whenever you want to resume
playback.
➜ resume shown and playback continues from where you have
stopped.
• To deactivate RESUME, switch the slider to OFF.
➜ resume goes off.
HOLD – locking all buttons
You can lock all buttons of the set. When you
press any key, no action will be executed then.
1 Switch the slider to HOLD to activate
HOLD.
➜ resume is shown and Hold is
displayed. All buttons are locked.
When pressing any key, Hold is displayed.
2 To deactivate HOLD, switch the slider to OFF.
➜ resume resume disappears.
ESP/ POWER SAVE MODE
With a conventional portable CD-player you
might have experienced that the music
stopped e.g. when you were jogging. The
ELECTRONIC SKIP PROTECTION prevents loss
of sound caused by light vibrations and
shocks. Continuous playback is ensured.
However ESP does not prevent playback
interruptions during vigorous running. It
also does not protect the unit against
any damage caused by dropping!
• Adjust the ESP slider to ON/OFF
position to select the following:
–
is shown and ESP is switched on.
–
disappears. Powersaving are switched on for CD Audio
tracks to achieve the highest sound quality.
A beep confirms that you have pressed a
button or that the batteries are empty.
• During music mode only keep DBB
pressed for 2 seconds to switch beep
either on or off:
➜ Beep On is displayed: Beep is
switched on.
➜ Beep Off is displayed: Beep is
switched off.
MUSIC AND GAMES
You can listen to music and play games at the same time. Select from 5
games: SNATCHER, MATCHER, COPTER, BREAKER and MUNCHER.
To start a game
1 If necessary, press 2; to switch on the
set.
2 Press GAME.
➜ Display shows the games main
menu. The current game is
highlighted.
3 Press 3 or 4 to scroll through the list
of games.
4 To confirm your game selection, press
PROGRAM/ SHOOT/ SELECT.
5 Press 3 or 4 to scroll through the
game submenu.
➜ Display shows Start, Level,
Speed, Top Score.
6 Press PROGRAM/ SHOOT/ SELECT to
confirm and start play.
How to control your game
Use the buttons on the set to navigate:
Up 3
Left ∞
• Press PROGRAM/ SHOOT/ SELECT to SHOOT/ confirm an action.
End game
To quit the game function you can:
• Press GAME once or more until the display returns to the music
mode display.
• Press 9.
Note:
–
This unit automatically switches off the beep signal when you select the
game mode during music playback. The beep signal automatically returns
when you quit GAME. For more details on the beep signal, please read the
BEEP chapter.
BEEP
Down 4
Right §
Publicité
