DeWalt DW349 Traduction De La Notice D'instructions Originale page 9

All manuals and user guides at all-guides.com
If the supply cord is damaged, it must be replaced
by the manufacturer or an authorised D
Service Centre in order to avoid a hazard.
INTENDED USE
This jig saw is designed for professional sawing
applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This jia saw is a professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This tool is not intended for use by persons
(includiing children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible
for their safety. children should be supervised to
ensure that they do not play with the appliance.
OPERATION
Warning: Before attempting any of the
following operations, make sure that the
tool is switched off and unplugged and
that the saw blade has stopped. used
saw blades can be hot. The tool always
is supplied via residual current device
with a rated residual current 30mA or
less.
Blade Installation (fi g 2)
1. Push the saw blade locking lever (c) upward.
2. With teeth facing forward, insert the shank of
the saw blade into the blade holder as far as it
will go.
3. Release the lever.
4. Check to ensure blade is secure before cutting.
Adjusting the Shoe for Bevel Cuts
(fig. 3)
WARNING: Never use the tool when the
shoe is loose or removed. The shoe plate
can be set to a left or right bevel angle of up
to 45°.
TO SET THE BEVEL ANGLE
1. Pull the shoe beveling lever (g) out and away
from the saw to unlock the shoe (f) as shown in
Figure 3.
2. Slide the shoe forward to release it from the 0°
positive stop position.
3. The shoe can be beveled to the left or to the
WALT right and has detents at 15°, 30° and 45°.
E
4. Set the shoe to the desired bevel angle. Use a
protractor to verify angle accuracy.
5. Push the shoe beveling lever back towards the
saw to lock the shoe.
TO RESET THE SHOE FOR STRAIGHT CUTS
1. Pull the shoe beveling lever (g) out and away
from the saw to unlock the shoe (f) as shown in
figure 3.
2. Rotate shoe to an angle of approximately 0°
and then pull shoe backwards to engage the 0°
positive stop.
3. Push the shoe beveling lever back towards the
saw to lock the shoe.
Switching On and Off
1. To switch the tool on, squeeze the trigger
switch (a).
2. For continuous operation, squeeze the trigger
switch then depress the lock-on button (b).
Once lock-on button is depressed, release the
trigger switch.
3. To switch the tool off, release the trigger switch.
To switch the tool off, when in continuous
operation, squeeze the trigger and the lock will
disengage.
Variable Speed Control (fi g. 4)
A speed control wheel (h) is located on the top
of the saw. The speed increases as the wheel is
turned from a low speed setting of 1 to a high speed
setting of 7.
Cutting Action – Orbital or Straight
(fi g. 5)
WARNING: Check that the tool is not
locked ON before connecting it to a
power supply. If the trigger switch is
locked on when the tool is connected
to the power supply, it will start
immediately. Damage to your tool or
personal injury may result. This jig saw is
equipped with four cutting actions, three
orbital and one straight. Orbital action
has a more aggressive blade motion
and is designed for cutting in soft
materials like wood or plastic. Orbital
action provides a faster cut, but with a
less smooth cut across the material. In
orbital action, the blade moves forward
during the cutting stroke in addition to
the up and down motion.
ENGLISH
7