Taking A Reading - Elcometer 415 Guide D'utilisation

4 GETTING STARTED (continued)
4.6 SELECTING THE MEASUREMENT UNITS
The Elcometer 415 can take measurements in µm and mils. To set the
measurement units:
1 Press the '

2 Use the
alternate between 'µm' and 'mil', followed by the  softkey to
return to the main reading screen.
4.7 SCREEN ROTATION
Using the internal accelerometer, the gauge will automatically rotate
the display to allow the user to easily read the thickness value in any
orientation - 0°, 90°, 180° & 270°.
To enable / disable automatic screen rotation:
1 Press the '

2 Use the
between ' ' (disabled) and ' ' (enabled), followed by the 
softkey to return to the main reading screen.

5 TAKING A READING

The gauge should be calibrated before taking readings, see Section 7
'Calibrating the Gauge' on page en-6.
To take a reading:
1 Whilst holding the gauge perpendicular, gently place the probe
onto the surface.
The reading may be inaccurate if the probe is not held flat against the

surface.
2
The coating thickness is shown on the display.
'>1000µm' ('>40mils') indicates a reading outside the gauge range.

3 For subsequent readings, lift the probe off and then replace it on
to the coated surface.
Using ElcoMaster the Elcometer 415 can simultaneously transmit the
live reading to a PC or mobile device (Model T only) for report
generation, see Section 8 'Downloading Data' on page en-8 for more
information.
The Elcometer 415 calculates and displays statistical values as each
reading is taken, see Section 6 'Statistics' for details.
en-5
R
' softkey.
softkeys to highlight 'µm/mil' and press ' ' to

' softkey.
softkeys to highlight '

®
' and press ' ' to alternate
www.elcometer.com