Inserting/Changing The Batteries - CIMCO 11 1410 Notice D'emploi

inserting/changing the batteries

The device is powered with two 1.5 V AAA batteries.
You needto insert a new, charged battery prior to initial
operation or when the battery change symbol
on the display.
To insert/replace the battery, proceed as follows:
- Separate the connected measuring leads from the
measuring circuit and the measuring device. Switch off
the meter.
- Loosen the two screws on the reverse side of the
battery cover and lift off the battery cover.
- Insert two new batteries in the battery compartment
observing the correct polarity.
- Now, close the cover carefully again.
never operate the measurement device when it is
open. !riSK oF Fatal inJurY!
Do not leave flat batteries in the device. even batteries
protected against leaking can corrode and thus release
chemicals which may be detrimental to your health or
destroy the battery compartment.
Do not leave batteries lying around carelessly. they
might be swallowed by children or pets. if swallowed,
consult a doctor immediately.
remove the batteries if the device is not used for longer
periods of time to prevent leaking.
leaking or damaged batteries may cause alkali burns if
they come in contact with the skin. therefore, use suitable
protective gloves.
make sure that the batteries are not short-circuited.
Do not throw batteries into fire!
Batteries may not be recharged. Danger of explosion.
appears
-
+
+
-
45