Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5 Selection 1 or 2 operators functioning
1. Scroll down the parameters with
lise P030;
2. Access the parameter by pressing the
3. Acting on
and
- d001=for a single motor operating;
- d002=for 2 motors operating;
4. Confirm your choice by pressing the
to P030).
6 Motor stroke learning
1. Scroll down the parameters with
2. Access the parameter by pressing the
3. When "
" flashes, continue pressing the
4. Release the
key when "
5. Wait for the door (or doors in case of using 2 motors) searches and stops on the opening stop and then on the closing stop.
If you want to anticipate the stopping strokes in opening, you can manually intervene by giving an impulse to "Start" button (or
pressing the "OK" on the control panel) simulating the stroke.
6. Once the procedure is ended, the display will show "- - - -".
WARNING Once you have executed the learning stroke, operate a complete cycle (opening/closing) and then check the manual release
to make sure it is working properly. If it's to "hard" increase the value of P057 of 1 or more.
7 Transmitters learning
7.1 Transmitters coding selection
1. Scroll down the parameters with
P027;
2. Access the parameter by pressing the
3. Select the type of transmitter by scrolling
- d000=fix rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the
Warning: If you need to vary the type of encoding, and only if other remo-
tes with different encoding are memorized, you need to erase memory
(P004) AFTER you have set the new encoding.
22
and
keys until you visua-
key;
keys, set:
key (display returns again
and
keys until you visualise P003;
key;
key;
" stops flashing; the learning procedure starts;
and
keys until you visualise
key;
and
keys:
key (display shows again P027).
Publicité
Table des Matières
