Pioneer GM-D9605 Mode D'emploi page 9

Connecting the units
Connecting the car stereo
Connect the RCA output jack of the car stereo
to the RCA input jack of the amplifier, or con-
nect the speaker output wire from the car
stereo to the speaker input terminal of the am-
plifier.
CH-A input (Two-channel input)
! Slide the 2CH-4CH INPUT SELECT (input
select) switch to the 2CH position.
! Slide the A/B-SW INPUT SELECT (input se-
lect) switch to the A/B position.
1
3
1 2CH-4CH INPUT SELECT (input select) switch
(2CH position)
2 RCA input jack A
3 From car stereo (RCA output)
If only one input plug is used, e.g. when the
car stereo has only one output (RCA output),
connect the plug to RCA input jack A.
4 Connecting wires with RCA plugs (sold sepa-
rately)
5 A/B-SW INPUT SELECT (input select) switch
(A/B position)
Notes
! For details on the speaker output, refer to Con-
necting the speakers on page 10.
! When the 2CH-4CH INPUT SELECT (input se-
lect) switch is set to 2CH, do not connect any-
thing to RCA input jack B.
2
5
4
CH-A CH-B input (Four-channel
input)
! Slide the 2CH-4CH INPUT SELECT (input
select) switch to the 4CH position.
! Slide the A/B-SW INPUT SELECT (input se-
lect) switch to the A/B position.
Connection when using the RCA input jack
Connection when using the SP INPUT (speaker
input) terminal
Notes
! When connecting the amplifier using the
SP INPUT (speaker input) terminal, do not
connect anything to the RCA input jack.
! For details on the speaker output, refer to Con-
necting the speakers on page 10.
CH-A CH-SW input
! Slide the 2CH-4CH INPUT SELECT (input
select) switch to the 2CH position.
! Slide the A/B-SW INPUT SELECT (input se-
lect) switch to the SW position.
Section
03
9
En