Connecting The Units; Connection Diagram; Before Connecting The Amplifier - Pioneer GM-D9605 Mode D'emploi

Connecting the units

Connection diagram

2 3 4
5
1
a
c
b
g
j
1 Battery wire (sold separately)
! The maximum length of the wire be-
tween the fuse and the positive + term-
inal of the battery is 30 cm (12 in.).
! For the wire size, refer to Connecting the
power terminal on page 12. The battery
wire, the ground wire and the optional
direct ground wire must be same size.
After making all other connections at
the amplifier, connect the battery wire
terminal of the amplifier to the positive
+ terminal of the battery.
2 Fuse (100 A) (sold separately)
Each amplifier must be separately fused at
100 A.
3 Positive (+) terminal
4 Negative (*) terminal
5 Battery (sold separately)
6 Ground wire, Terminal (sold separately)
The ground wires must be same size as the
battery wire.
7
8
6
9
e f
h i
Connect to metal body or chassis.
7 External output
If only one input plug is used, do not connect
anything to RCA input jack B or RCA subwoo-
fer input jack.
8 Car stereo with RCA output jacks (sold sepa-
rately)
9 Connecting wire with RCA pin plugs (sold se-
parately)
a Bass boost level remote control
b Bass boost level remote control wire (5 m
(16 ft. 5 in.))
c RCA input jack A
d RCA input jack B
e RCA subwoofer input jack
f Front side
g Fuse (30 A) × 3
h Speaker/subwoofer output terminals
Please see the following section for speaker
connection instructions. Refer to Connections
when using the speaker input wire on page 11.
i Rear side
j System remote control wire (sold separately)
Connect male terminal of this wire to the sys-
tem remote control terminal of the car stereo.
The female terminal can be connected to the
auto-antenna relay control terminal. If the car
stereo lacks a system remote control terminal,
connect the male terminal to the power term-
inal via the ignition switch.
Note
INPUT SELECT (input select) switch must be set.
For details, refer to Connecting the car stereo on
page 9.
Before connecting the
amplifier
WARNING
! Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap sections
in contact with metal parts in adhesive tape.
Section
03
7
En