Attaching The Bass Boost Remote Control; Example Of Installation On The Floor Mat Or Chassis - Pioneer GM-D9605 Mode D'emploi

Installation
Attaching the Bass boost
remote control
Attach with tapping screws (3 mm × 10 mm
(1/8 in. × 3/8 in.)) at an easily accessible loca-
tion such as under the dashboard.
Tapping screws (3 mm × 10 mm (1/8 in. × 3/8 in.))
Example of installation on
the floor mat or chassis
1 Place the amplifier in the desired instal-
lation location.
Insert the supplied tapping screws (4 mm ×
18 mm (1/8 in. × 3/4 in.)) into the screw holes
and push on the screws with a screwdriver so
they make an imprint where the installation
holes are to be located.
2 Drill 2.5 mm (1/8 in.) diameter holes at
the imprints either on the carpet or directly
on the chassis.
3 Install the amplifier with the use of
supplied tapping screws (4 mm × 18 mm
(1/8 in. × 3/4 in.)).
3
4
1 Tapping-screws (4 mm × 18 mm (1/8 in. ×
3/4 in.))
2 Drill a 2.5 mm (1/8 in.) diameter hole
3 Floor mat or chassis
4 Hole-to-hole distance: 307 mm (11-5/8 in.)
5 Hole-to-hole distance: 181 mm (7-1/8 in.)
Section
1
2
5
En
04
15