Kohler Vanity Instructions D'installation page 5

1. Prepare the Site
CAUTION: Risk of property damage. To properly support the weight of the
vanity and sink, secure to stud framing or 2x6 bracing behind the finished
wall.
NOTICE: To verify proper support and alignment: The finished wall must be straight
and plumb. The floor must be flat and perpendicular to the finished wall.
If installing 2x6 bracing, front-notch the studs 1-1/2" (38 mm) to verify that the
bracing sits flush against the studs. The bracing should span the length of the
vanity.
Plan for routing supply and drain piping for your desired sink installation
Plan for electrical service if installing the optional electrical strip. Any electrical
accessory components must be connected to a circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI) or Residual Current Device (RCD).
Complete the finished wall.
Kohler Co.
Plan the plumbing area for the sink.
2x6 Bracing
34-1/2" (876 mm)
5
1216526-2-G