Vortice VORT HRI PHANTOM Livret D'instructions page 23

ENGLISH
- PROF: settings for operation with time profiles:
P1, used to program one period of operation per day, with a start time, an end time and a fan speed;
P2, used to program two periods of operation per day, each with a start time, an end time and a fan speed. The user can
allocate a different profile to each day of the week.
- HA: settings for operation in HA mode: available only on appliances equipped with HA module, and only if operation of
the main system with time profiles has not been enabled.
- SERV: service (option available only to the installer)
PROF option
19 19
FILT
1 2 3
esc
Prg
/ °C
By-Pass
- ST: start time, profile P1 interval
- END: end time, profile P1 interval
- SP: speed, profile P1: possible values are 1, 2, 3
- ST1: start time, profile P2 interval 1
- EN1: end time, profile P2 interval 1
- SP1: speed, profile P2 interval 1: possible values are 1, 2, 3
- ST2: start time, profile P2 interval 2
- EN2: end time, profile P2 interval 2
- SP2: speed, profile P2 interval 2: possible values are 1, 2, 3
- MON: allocation of profile to Monday: possible values are P1 and P2
- TUE: allocation of profile to Tuesday: possible values are P1 and P2
- WED: allocation of profile to Wednesday: possible values are P1 and P2
- THU: allocation of profile to Thursday: possible values are P1 and P2
- FRI: allocation of profile to Friday: possible values are P1 and P2
- SAT: allocation of profile to Saturday: possible values are P1 and P2
- SUN: allocation of profile to Sunday: possible values are P1 and P2
HA Option
20 20
FILT
1 2 3
esc
/ °C
By-Pass
- ST: start time, profile P1 interval
- END: end time, profile P1 interval
- SP: speed, profile P1: possible values are 1, 2, 3
P1 P2 HA
4 5 6 7
set
P1
P2 HA
4 5 6 7
set
Prg
Selecting HA by pressing SET, the settings for HA operating
mode are accessed. The parameters
- En (Enable): possible values are: ON: enables operation with
profiles (and as noted above, automatically disables any
possibility of operation in HA mode) OFF: disables operation
with profiles.
If EN ON has been selected, the following parameters are also
enabled:
This option is available only on models equipped with HA
module, and only if operation of the main system with time
profiles has not been enabled. Selecting HA by pressing SET,
the settings for HA operating mode are accessed. The
parameters are:
- En (Enable): possible values are:
PROF: enables HA mode with profiles
ON: enables HA mode continuously
OFF: disables HA mode
HOL: enables HOLIDAY mode: two hours antibacterial
operation per day, two hours refresh, 20 hours stand-by.
If EN PROF has been selected, the following parameters are
also enabled:
are:
23