Maintenance; Trouble-Shooting Guide - Carat X-COUP Mode D'emploi

16

Maintenance

Before performing any maintenance, make sure the machine is isolated from any electrical supply.
To ensure a long-term quality, make the following maintenance actions every time after using the machine:
• Inspect visually the whole machine
Clean flange and blade fixing devices
•
• Clean Motor (housing + cooling fans), water tray, water pump, water pump filter, water hoses and nozzles, table
guiding rails, table wheels
• Make sure all bolts and screws are tighten
Before using the machine, make sure all above actions have been done.
17

Trouble-shooting guide

Before performing any reparation, make sure the machine is isolated from any electrical supply.
Attention: Any works dealing with the electrical system or supply of the machine should be performed only by a
qualified electrician.
Troubles
Machine doesn't work
No water on the blade
Motor stops during cutting (thermal
Possible causes
No electricity
Defective cable
Defective switch
Defective motor
Not enough water in the water tray
Closed water tap
Clogged water system
Defective water pump
Water pump is off
Wrong blade for the application
40
Resolutions
Check the supply cable
Make sure it is plug correctly
Change the cable
Change the switch
Change the motor
Refill with clean water
Open the water tap
Clean the water system
Clean or change the water pump
Check electric circuit
Change the blade