Transport; Storing; Tool Assembly - Carat X-COUP Mode D'emploi

7

Transport

Before transporting the machine always do the following instructions:
• Remove the blade
• Empty the water tray,
Lock the table
•
Fold and tight the legs with the locking screws
•
Make sure the transport handles and wheels are mounted correctly and well tighten.
•
The machine can be transported by two persons using the transport handles or one person using the transport wheels.
The machine is not designed to be transported by crane!
8

Storing

Before storing always do the following instructions:
• Clean the machine
• Empty and clean the water tray
• Clean the water pump
• In case of frost, empty all water cooling system from its water.
Store the machine in a dry place and not accessible to children.
9

Tool assembly

To mount a new blade, always do the following instructions:
• Switch off the machine and unplug the supply cable. (1)
• Loose the screw which on the back of blade guard. And rotate the blade guard. (2)
• Loose the left threaded hexagonal nut on the motor shaft and remove the outer flange and the tool. (3)
• Clean the tool shaft and flanges and inspect for wear. (4)
• Mount the new blade. Make sure the tool rotation is correct and the bore corresponds to the shaft diameter.
mount back the outer flange and tighten the left threaded hexagonal nut on the motor shaft (5)
Rotate the blade guard back in place. Tighten the screw. (6)
•
35