Carat X-COUP Mode D'emploi page 39

To put the cutting head back in the normal position, please follow this procedure:
Switch off the machine and make sure the blade is not rotating. (1)
•
• Put the table at the front of the machine to clear the space for the pivoting of the cutting head. (2)
• Loosen the big nut at the back of the cutting head. (3)
Rotate the cutting head until it stops at 0°. (4)
•
• Tighten well the big nut at the back and use your hand to maintain the position of the cutting head at 0° (because
the tighten torque could slightly modify the angle possible of the cutting head!). (5)
• Make sure the blade is not touching the table at any position of the table when the cutting head is at the lowest
position. (6)
39