Cutting Method: 45° Bevel Cuts - Carat X-COUP Mode D'emploi

• Use your right hand to adjust the depth while cutting, Use your left one to slide the table back and forth. (9)
15 Cutting method: 45° bevel cuts
The X-COUP enables to make fixed or multiple steps 45° bevel cuts.
To do 45° bevel cuts, please follow this procedure:
• Switch off the machine and make sure the blade is not rotating. (1)
• Put the table at the front of the machine to clear the space for the pivoting of the cutting head. (2)
• Loosen the big nut at the back of the cutting head. (3)
• Rotate the cutting head until it stops at 45°. (4)
Tighten well the big nut at the back of the cutting head. (5)
•
• Loosen the adjusting handle. (6)
Adjust the depth stop and tighten the counter nut to fix it well. (7)
•
• Make sure the blade is not touching the table at any position of the table when the cutting head is at the lowest
position. (8)
• Put material on the table, adjust the position using the guide-a-cut.
Start the machine. (9)
•
• Push the table slowly and without undue pressure towards the rotating blade.
38