Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing the Top Plate to an Ulterra
1
WARNING
Make sure that the Power Cables from the battery are
disconnected, or that the breaker, if equipped, is "off."
NOTICE:
A motor may weigh up to 65lbs. We
recommend having a second person help with
the installation.
a.
Place the mount on an elevated, level surface such
as a workbench or the tailgate of a pickup. The
motor should be in the stowed position.
NOTICE:
Ulterra installation will use hardware that was
included with the Ulterra motor. The hardware needed
will be six Stainless Steel Screws (#2203431) and
six Clipped Washers (#2201725) from the Ulterra bag
assembly (#2994917).
2
b.
Using a #3 Screwdriver, remove the Sideplates to
access the Mounting Slots.
3
c.
Under the Left Sideplate, the Extension Damper
obstructs access to the left front Mounting Hole.
d.
Using a small Screw Driver, remove the two
5/16" e-clips holding the Extension Damper in place.
Once the e-clips are removed, slide the Extension
Damper off the Damper Pins to expose the left rear
Mounting Hole. Set the two e-clips and Extension
Damper in a safe place so they are not misplaced
before they are reassembled later in the installation.
WARNING
Do not deploy the motor until it is fully mounted to the boat.
Illustrations are for reference only. Deploying your motor
before it is mounted to the boat may cause injury.
6 | minnkotamotors.com
Power Cables
Power Cables
Deployed
Deployed
WARNING
Do not deploy the motor until it is fully mounted to the boat.
Illustrations are for reference only. Deploying your motor before
it is mounted to the boat may cause injury.
2b
Right
Right
Sideplate
Sideplate
3c
E-clip
E-clip
Extension
Extension
Damper
Damper
3d
E-clips
E-clips
Stowed
Stowed
2b
Left Sideplate
Left Sideplate
E-clip
E-clip
Mounting Hole
Mounting Hole
Extension
Extension
Damper Pins
Damper Pins
Damper
Damper
©2020 Johnson Outdoors Marine Electronics, Inc.
Publicité
Table des Matières
