Johnson Outdoors MINN KOTA MKA-51 Guide D'installation page 4

4
ITEM(S) NEEDED
#4 x 6
h. Place the flat side of the Top Plate against the
bottom of the Base Extrusion. Align the Mounting
Holes in the Top Plate with the Mounting Holes in
the Base Extrusion that were exposed when the
sideplates were removed. Make sure that the Cam
Lever is located on the mount closest to the Power
Cord. The appearance of your Base Extrusion may
vary depending on motor type.
i. Use six each of the 1/4-20 X 7/8 Stainless Steel
Screws (Item #4), 9/32 X 5/8 X 1/16 Flat Washers
(Item #10) and 1/4-20 Nylock Nuts (Item #6) to
secure the Top Plate to the Base Extrusion. It is
recommended to use a minimum of two screws on
each side, placing them the farthest apart on the
mount. The screws will pass from the bottom up,
through the Top Plate and then the Base Extrusion.
The Flat Washers are placed on the screws on top
of the Base Extrusion, and then secured with the
Nylock Nuts. Tighten the Nylock Nuts with the
7/16" Box End or Open End Wrench. Make sure all
hardware is secure.
5
j. After the Top Plate is secured to the Base Extrusion,
replace the Right Sideplate.
k. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
l. Replace the four sideplate screws using a #3
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
5j
4 | minnkotamotors.com
#10 x 6 #6 x 6
Right Sideplate Right Sideplate
Nylock Nuts Nylock Nuts
Flat Washer Flat Washer
Base Extrusion Base Extrusion
Power Cord Power Cord
Exits Here Exits Here
Top Plate Top Plate
Inboard Inboard
Mounting Mounting
Holes Holes
NOTICE:
To prevent seizing of the stainless steel hardware,
do not use high speed installation tools. Wetting the screws
or applying an anti-seize may help prevent seizing.
5k
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
5l
Outboard Outboard
Mounting Mounting
Holes Holes
Stainless Stainless
Steel Screw Steel Screw
Sideplate Screw Sideplate Screw
©2020 Johnson Outdoors Marine Electronics, Inc.