Handset Information - Siemens HiPath 3000 Mode D'emploi

Handset Information

Important notes
The information provided in this document contains merely general
descriptions or characteristics of performance features which in
case of actual use do not always apply as described or which may
change as a result of further development of the products.
An obligation to provide the respective performance features only
exists if expressly agreed in the terms of contract.
The trademarks used are owned by Siemens AG or their respective
owners.
Read the safety instructions and user manual before using
the handset.
Make sure that your children are familiar with this informa-
tion and the dangers of using the handset.
• It is recommended that standard acceptance procedures be fol-
lowed prior to operating this equipment in proximity of life-sup-
port systems.
• To minimize risk of interference, pacemaker users should not
carry the WT next to the pacemaker.
• Earpiece may retain magnetic objects.
• Operation of the WT may produce an audible noise noticeable
to hearing aid users. It is recommended that a hearing aid com-
patible headset be used by hearing aid users.
• This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by Siemens could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a certified in-
stallation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interfer-
ence to radio communications. Contact your installer or
Technical Support if you believe this equipment is causing
interference.
This model phone meets the government's require-
ments for exposure to radio waves
This wireless phone is a radio transmitter and receiver. It is designed
and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. The exposure standard for
wireless mobile phones employs a unit of measurement known as
the Specific Absorption Rate, or SAR. Tests for SAR are conducted
using standard operating positions specified by the FCC with the
phone transmitting at its highest certified power level in all tested
frequency bands. The standard incorporates a substantial margin of
safety to give additional protection for the public and to account for
any variations in measurements. The FCC has granted an Equip-
Handset Information
17