Changing Brightness Of The Display; Automatic Spacing; Adjusting The Output Level - Yamaha CDX-397MK2 Mode D'emploi

You can change brightness of the display
in three degrees by pressing DIMMER.
If you record a disc onto tape with an insufficient time space between tracks, the tape deck will not be able to perform blank
search operations on the tape correctly. To enable a track search operation, use this function to add an interval of about 4
seconds between tracks.
Press SPACE to light up the current setting.
SPACE
While the current setting is lit up, press SPACE to
change the setting between "AUTO SPACE ON" and
"AUTO SPACE OFF".
You can adjust the level of signals output to the amplifier by
pressing OUTPUT LEVEL +/– .

Changing brightness of the display

Automatic spacing

Light up about 3 seconds.

Adjusting the output level

OUTPUT
LEVEL
DIMMER
Notes
When the automatic spacing function is in effect, the display of
the total time and of the total remaining time includes each
interval of the 4 seconds between tracks.
When the automatic spacing function is in effect during the
playback, "AUTO SPC 4" (the remaining seconds of the
interval) appears and is counted down each time blinking at the
interval between the tracks.
Note
While playing back an MP3/WMA disc, the level of the audio
signal sent to the DIGITAL OUT (OPTICAL) terminal is fixed at
maximum regardless of the displayed volume level.
Normal illumination
Slightly dim
Dim
11
En