Honeywell Home HE120 Instructions D'installation page 6

HE120 BY-PASS DRUM HUMIDIFIER
Fig. 5. Cutting Humidifier opening.
6. Disassemble the Humidifier; remove the cover by
lifting up on the front edge and take out the drum
components, Water Pan, and Motor Plate.
7. Position the HE120 Humidifier Housing over the
opening (make sure it is level) and mark the five
mounting holes. See Fig. 6.
8. Remove the HE120 Humidifier Housing and pre-drill
the mounting holes using a 1/8 in. drill bit
9. Start the three #8 x 3/4 in. Sheet Metal Screws in
the top holes.
69-1860EF—02
STARTING HOLE
M13618
6
MOUNTING HOLES
MOUNTING HOLES
Fig. 6. Marking Mounting Hole locations.
10. Place the Humidifier Housing over the screws, level
the housing and tighten the three screws. See Fig. 7.
11. Secure the bottom of the Humidifier Housing using
two #8 x 3/4 in. Sheet Metal Screws.
Fig. 7. Mounting Humidifier.
12. Check that the Humidifier is level.
M13619