Baseplate - Honeywell Home HE120 Instructions D'installation

HE120 BY-PASS DRUM HUMIDIFIER
5. Unscrew the Back Cover of Humidistat and remove.
See Fig. 39.
6. Unscrew the two Base Plate screws and remove the
Control Assembly. See Fig. 44.
BASE PLATE SCREWS
Fig. 44. Removing Control Assembly from Base Plate.
7. Snap two Screw Terminals over the blade terminals
on the Control Assembly. See Fig. 40.
8. To assemble control for wall mounting (See Fig. 45):
a. Drill clearance hole in plastic Base Plate for low
voltage wiring with 3/8 in. drill bit.
b. Turn over the Base Plate so text faces the wall.
c. Place the Control Assembly on the Base Plate
with the dial shaft facing away from the plate.
d. Screw the Control Assembly to the Base Plate
using the two Base Plate screws.
BASE PLATE
CONTROL ASSEMBLY
DIAL SHAFT
Fig. 45. Mounting Humidistat.
9. Position the Base Plate horizontally over the wire
and pull the wire through the hole.
10. Connect the wires to the Screw Terminals on the
Control Assembly. See Fig. 41 on page 17.
11. Secure Base Plate to the wall using four #6 x 1 in.
Sheet Metal Screws. See Fig. 46.
69-1860EF—02
M13634
BASE PLATE
SCREWS (2)
DRILL 3/8 IN.
CLEARANCE
HOLE IN PLASTIC
M13612
WALL
SHEET METAL
SCREWS (4)
Fig. 46. Mounting Humidistat.
12. Remove the backing and adhere the Humidistat
Label to the recessed area of the front of the Humid-
istat Cover. See Fig. 47.
ALIGN HOLE IN COVER
WITH HOLE IN LABEL
FOR CORRECT PLACEMENT
Fig. 47. Adhere Humidistat Cover Label.
13. Secure the Humidistat Cover to the Control Assem-
bly using one 3/8 in. screw. See Fig. 48
14. Push the Setpoint Dial onto the control shaft.
3/8 IN.
SCREW
SETPOINT DIAL
Fig. 48. Assembling Humidistat Cover.
18
BASE PLATE
WITH CONTROL
ASSEMBLY
MOUNTED
M13635
M13636B

BASEPLATE

1 0
6 0
COVER
M13614A