Empire Comfort Systems DVP36PKR-1 Instructions D'installation

PORCELAIN PANEL MODELS
DVP36PKR - 1
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION
HARDWARE PACK CONTENTS
Part
Description
Number
B101569 Self-Drilling #10 Screw
R2737
34806 Brick Spacer Bracket
29270 Brick Retainer Bracket
TOOL REQUIRED: Electric Screw Gun with 5/16" Hex Driver
NOTICE: This sequence may be used to install panels into either
side of the firebox.
NOTICE: The false floor included with the log kit or boulder kit
must be installed prior to installing the fiber or porcelain panels.
NOTICE: The fiber or porcelain panels sit in front (NOT behind)
of the brick brackets shown in Figures 2 and 3.
1. From either side of the fireplace, remove the lower access panel.
2. The two glass spring-latches are on the bottom of the glass
frame. Release them by pulling them away from the fireplace
and down. Remove the screen frame and glass frame as a
unit (separating them is not necessary) by lifting them up and
away from the fireplace. See Figure 1.
36226-2-0220
INSTALLATION INSTRUCTIONS
FIBER & PORCELAIN PANEL KITS
FOR USE ON: DVCP36(PP,SP)(3,7)-1 FIREPLACES
Quantity
Supplied
#10 Screw
Figure 1
Empire Comfort Systems Inc. • Belleville, IL
FIBER PANEL MODELS
DVP36PRB-1
3. Set the brick bracket against the firebox wall as shown in
Figure 2.
3
4
2
1
4. Screw the brick bracket to the false floor (but do not tighten)
with the screws shown on the left side of Figure 3 (Vent /
Pilot side panel only).
5. Use the self-drilling screws shown on the right side of
Figure 3 to attach the brick bracket to the firebox wall.
DVP36PFLKR-1
FALSE FLOOR
Figure 2
1
Figure 3
2
Page 1