Dell PowerConnect 7000 Serie Guide De Mise En Route page 23

Select Terminal keys for Function, Arrow, and Ctrl keys. Make sure
f
that the setting is for Terminal keys (not Microsoft Windows keys).
NOTE:
that you have Windows 2000 Service Pack 2 or later installed. With Windows
2000 Service Pack 2, the arrow keys function properly in HyperTerminal's
VT100 emulation. Go to microsoft.com for more information about Windows
2000 service packs.
3 Connect the RJ-45 connector on the cable directly to the switch console
port. The PowerConnect 7000 Series console port is located on the right
side of the front panel and is labeled with a |O|O| symbol, as shown in
Figure 1-14.
NOTE:
the console port of the Master switch. If you connect the terminal to a
subordinate switch, you will not be able to use the CLI.
Figure 1-14. Console Port Location
Console Port
The RJ-45 port to the right of the console port is for out-of-band
management.
When using HyperTerminal with Microsoft Windows 2000, make sure
If you are configuring a stack of switches, connect the serial cable to
Getting Started Guide
21