Technical Data - EINHELL WIS 700/400 Mode D'emploi

Anleitung WIS 700-400 SPK1
balance at all times.
Check the tool for damage.
Each time before re-using the tool, carefully check
that the guards or any slightly damaged parts are
working as intended.
Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted
correctly and that all other operating conditions
are properly fulfilled.
Unless otherwise stated in the operating
instructions, damaged safety devices and parts
must be repaired or replaced by an authorized
service center.
Have damaged switches replaced by a customer
service workshop.
This electric tool complies with the pertinent safety
regulations. Repairs are to be carried out only by
a qualified electrician using original replacement
parts or the user may suffer an accident.
If necessary, wear suitable personal protection
equipment. This could consist of:
- Ear plugs to prevent the risk of damaging your
hearing;
- A breathing mask to avoid the risk of inhaling
hazardous dust.
- Always wear gloves when handling saw blades
and rough materials. Whenever practicable, saw
blades must be carried in a container.
The operator must be informed about the
conditions that influence the generation of noise
(for example saw blades designed to reduce noise
emissions, caring for blades and the machine).
Faults on the machine or its guards, safety
devices and blade must be reported to the person
in charge as soon as they are discovered.
Use only the transport devices to move the
machine. Never use the guards for handling and
moving the machine.
All operators must receive proper training in the
use, adjustment and operation of the machine.
Do not saw any materials that contain foreign
bodies such as wires, cables or ties.
Only use sharp saw blades.
Important:
Risk of injury!
Never reach into the
running saw blade.
Wear goggles
20.03.2006 7:59 Uhr Seite 15
Wear ear-muffs
Wear a breathing mask
Sound pressure level LPA
Sound power level LWA
The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.

5. Technical data

AC motor: 400 V 3 ~ 50 Hz
Power P:
Power P: 4500 W S6 20%
Protection type:
Idle speed n :
0
Saw blade: Ø 700 x Ø 30 mm
Number of teeth:
Max. cutting capacity (reversing cut):
Min. cutting capacity:
Max. material length:
Min. material length:
Weight:
Operating mode S6 20%: Continuous operation with
idling (cycle time 10 minutes). To ensure that the
motor does not become excessively hot it may only
be operated for 20% of the cycle at the specified
rating and must then be allowed to idle for 80% of
the cycle.
GB
mode
100 dB(A)
115 dB(A)
4000 W S1
IP 54
1440 rpm
64
270 mm
25 mm
1000 mm
300 mm
94 kg
15