Connecting The Am Antenna - JVC VS-DT6 Manuel D'instructions

Getting Started

Connecting the AM Antenna

Rear Panel of the Center Unit
AM loop antenna (Supplied)
Attach the AM loop to its base by snapping the tabs on
the loop into the slot in the base.
• The AM loop antenna can be attached to a wall.
Screw (not supplied)
• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord.
This could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop
antenna connected.)
5
SPEAKERS
H V
R L
DISP.SET
CD DIGITAL
SPEAKER IMPEDANCE 4 16
SUB
WOOFER
OUT
AC IN
ANTENNA
AM
LOOP
Turn the loop until you have the best reception.
ANTENNA
FM
(75 )
COAXIAL
AM
LOOP
OUT
MD/AUX
IN
AM
EXT
FM
(75 )
COAXIAL
AM
EXT
Outdoor single vinyl-
covered wire
(not supplied)