Extinguishing The Fire - HAMPTON BAY 51859 Guide D'utilisation Et D'entretien

Operation (continued)
4
Using a long match/lighter to light
WARNING: Lava rocks can become very hot. DO NOT touch unless they are completely cooled.
□ Connect the propane (LP) cylinder (see step 5 in the Assembly section).
□ Before lighting, move the lava rocks to allow access to the burner.
□ Locate the burner control knob and make sure it is in the "OFF" position.
□ Wearing heat resistant gloves, position a long lit match or lit lighter close to the burner ports. DO NOT lean over the burner while
lighting.
□ Push and turn the control knob to the "LOW" position. The burner should light within 5 seconds.
□ If the burner does not light, turn the burner control knob to "OFF" position, wait 5 minutes and repeat the lighting procedure. If the
burner still will not light, refer to the Troubleshooting section.
□ Flame height can be changed by adjusting the burner control knob between the HI and LO (low) positions.
□ Always check the burner flames periodically to ensure proper operation. Flames should be mostly yellow with some blue for best
performance. (See diagram on previous page)
□ Wait 50 minutes after extinguishing flame prior to placing the lid (if applicable) or a protective cover on the heating item.
5
Performing a visual check
□ Prior to each use, check the hose and valve for excessive
wear, abrasions or any damage.
BURNER TUBE
ORIFICE
METAL FLEX
TUBE
REGULATOR
HOSE
12
6

Extinguishing the fire

□ Push and turn the burner control knob to the "OFF" position
and close the LP tank valve.
□ Disconnect the regulator from the LP tank to close the gas
supply when not in use.
□ Make sure that the unit is completely cooled before
touching any of the components or putting on the cover.
LP TANK