Operation; Selecting A Location; Lighting A Fire - HAMPTON BAY 51859 Guide D'utilisation Et D'entretien

Operation

1

Selecting a location

□ Always place this outdoor fire table on a hard, level non-
combustible surface such as concrete, rock or stone.
□ Please ensure that the minimum clearances are maintained
between the fire table and combustible surfaces. (See
below).
□ Position the fire table so that you have easy access to the
control knob and door.
MIN. CLEARANCE
48 in. (122 cm.)
2
Performing a leak test
□ Perform a leak test in a well ventilated area outside.
□ Make sure any open flames or cigarettes are extinguished.
□ Remove the battery.
□ Ensure the burner control knob is in the "OFF" position.
□ In a bowl, create a soap solution using 1 part water and 1
part liquid detergent.
□ Apply the soapy water solution to all connections before
attempting to light the fire table.
□ A gas leak will be detected by expanding bubbles
originating from the point of the leak.
□ If a leak is found at any connection point or if you smell
gas, close the tank valve, disconnect the tank and do not
use the fire table until repairs can be made.
LEAK
MIN. CLEARANCE
48 in. (122 cm.)
MIN. CLEARANCE
48 in. (122 cm.)
MIN. CLEARANCE
48 in. (122 cm.)
NO LEAK
3

Lighting a fire

CAUTION: If the burner does not ignite with the burner
control valve open, gas will continue to flow out of the
burner and could accidentally ignite causing injury or
property damage.
□ Connect the propane (LP) cylinder (see step 5 in the
Assembly section).
□ Before lighting, move the lava rocks to allow access to the
burner.
□ Locate the burner control knob and make sure it is in the
"OFF" position.
□ Push and hold in the electronic igniter to create sparks
within the electrode, continue to hold.
□ Push in the control knob and turn to the "low" position.
Keep holding down the control knob to allow gas to flow for
45 seconds.
□ If the burner does not light, turn the burner control knob
to "OFF" position, wait 5 minutes and repeat the lighting
procedure. If the burner still will not light, refer to the
Troubleshooting section.
□ Once the fire table is lit, flame height can be changed by
adjusting the burner control knob between the "High" and
"Low". Always check burner flames periodically to ensure
proper operation. Flames should be mostly yellow with
some blue for best performance.
IGNITER PUSH
11
Please contact 1-855-HD-HAMPTON for further assistance.
10
in.
25
cm.
2
in.
5 cm.
OFF
LOW
HIGH
HAMPTONBAY.COM