Kohler K-77685 Guide D'installation Et D'entretien page 3

Before You Begin (cont.)
Observe all state and local plumbing and building codes.
Contaminants or other substances removed or reduced by this
filtration system may not be present in your water. Refer to the
Performance Data Sheet (included) for contaminants and
reduction performance.
Inspect the plumbing and supplies for damage. Repair or replace
as needed.
Install the water filtration system to a cold water supply only. Do
not install the system to a hot water supply.
The water filtration system is designed to be installed beneath a
sink. Make sure the bottom of the filter cartridge is at least 2" (51
mm) above the floor of the cabinet, and will be accessible for
filter cartridge replacement after installation.
Replace the filter cartridges every 6 months, when the capacity
has been exceeded, or when a noticeable decrease in water flow is
observed.
Flush the filter system thoroughly after prolonged periods of non
use. Allow the water to flow for 5 or 6 minutes before use.
This system connects to a 3/8" (9/16"-24 UNEF-2A) compression
connection. Special fittings may need to be purchased to
accommodate other connections.
Record your model number and installation date below. Also
mark the installation date on the filter head and filter cartridges.
Model number: ____________ Replacement date: _____________
Keep this manual for future reference.
Kohler Co. 3 1285422-2-A