Cleaning And Maintenance - Heaven Fresh HF 210UV Mode D'emploi

CLEANING AND mAINTENANCE

Make sure unit is unplugged before performing any maintenance!
1. Cleaning the Dust Collection Plates:
The dust collection plates should be cleaned about every 20-30 days, or when covered
with dirt and residue. Cleaning the dust collection plates is very simple. First, twist the
knob on the right hand side of the air purifier and pull the plates out. Second, wipe the
plates off with a damp cloth. If there is difficult-to-remove residue on the plate, you
should use a mild household cleaner, such as detergent, to help remove it. Third, dry
the plates. Fourth, reinsert the plates back into the air purifier. Twist the handle to lock
them in place and so that the unit will operate again. Please refer to the lock and unlock
symbols on the handle of dust collection plate.
1. Removing the dust collection plates.
Note: When removing the collector plates for periodic cleaning, please note that it must be
returned to the unit in exactly the same position for a flush fit. Reversing the position will
result in an incomplete closure and the unit will not function properly.
CAUTION
Plate's edges are sharp so please use a towel or thick fabric to avoid injuries.
2. Maintenance of the Negative Ion-Producing Electrodes (Needlepoints)
Periodically, enough dust and particulate will accumulate on the tips of each pin,
potentially weakening the performance of the air purifier. Every 2-3 months or if the HF
210UV starts making a loud hissing sound, zapping sound, or seems to be "sputtering",
follow the instructions below to clean off the tips of each pin.
Light dust coverage cleaning: There are two flexible scraping pads at the end of dust
collection plate. When you unlock and pull out the dust-collection plates, these two scrapers
will brush against the ends of each pin, removing the dust and particulate. Repeat this
process multiple times as needed.
Heaven Fresh
2. Wiping dust collection plates clean.
5 HF 210 UV