Cleaning & Maintenance - Heaven Fresh HF 60 Mode D'emploi

oPERatinG inStRuCtionS
Use the adhesive strip provided to secure the HF 60 firmly on the dashboard with
the six air outlets facing the interior of the vehicle.
Insert the unit's DC plug into the cigarette lighter socket. Move the switch, located
on the side of the device, to the [ON] position. The green light will appear when in
operating mode. Turn the switch to the [OFF] position to stop operation.
Note: In some vehicles the power to the cigarette lighter socket will cut off when
the vehicle is not operating.
CLEaninG & MaintEnanCE
The unit will need cleaning about every two months. Please clean as follows:
1. Unplug from the socket. Hold the top of the
unit with one hand and using the other hand
carefully remove the upper cover by inserting a
small coin into the two release slots located at
the rear of the unit and twisting slightly. It is not
necessary to remove the lower part of the unit
from the dashboard for cleaning. Be careful not
to break the four positioning locks inside the
base of the unit.
2. Use a cotton swab dipped in alcohol to wipe the electrode needles and the
dust collector plate with the six holes. Be careful not to damage the internal
electronic circuitry.
3. Important: Please be sure to remove any remaining moisture with a small
dry cloth and allow the unit to dry thoroughly before closing the cover. You
can operate the device after it is thoroughly dry.
Heaven Fresh 3 HF 60