Product Maintenance - Fellowes Powershred Shredmate Manuel D'utilisation

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Set to Auto-On (
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4 minutes will trigger
15-minute cool down period.

PRODUCT MAINTENANCE

OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse (R) Alternate slowly back and forth
for 2-3 seconds
LIMITED PRODUCT WARRANTY
in material and workmanship and provides service and support for 1 year from the date of purchase
by the original consumer. Fellowes warrants the cutting blades of the machine to be free from
defects in material and workmanship for 1 year from the date of purchase by the original consumer.
If any part is found to be defective during the warranty period, your sole and exclusive remedy will
not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder
operation using an improper power supply (other than listed on label), or unauthorized repair.
Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to
2 3
I Feed paper/card When finished shredding
)
straight into paper set to OFF (O)
entry and release
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Set to Off (O) * Apply oil
3 4
Set to Off (O)
and unplug
3
Set to Reverse (R)
2-3 seconds
across entry
5 6
Set to Auto-On (I) and
Gently pull uncut
resume shredding
paper from paper
entry. Plug in.
provide parts or services outside of the country where the shredder is initially sold by an authorized
conditions of this warranty are valid worldwide, except where different limitations, restrictions, or
please contact us or your dealer.
Shredder doesn't start:
Make sure head is on basket correctly
Wait 15 minutes for motor to cool down
Remove and empty basket
3