Product Maintenance - Fellowes POWERSHRED W11C Manuel D'instructions

BASIC SHREDDING OPERATION
Continuous operation:
Up to 5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
5 minutes will trigger a
20-minute cool down period.
Safety Lock prevents accidental operation.
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse (R) Alternate slowly back and forth
for 2-3 seconds

PRODUCT MAINTENANCE

OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 1 year from the date of
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
PAPER/CARD
1
2
straight into paper
entry and release
To set, wait for shredding to stop, push black button down and slide towards front of shredder.
4
3
and unplug
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
3
When finished shredding
5
6
Gently pull uncut
paper from paper
(I) and resume
entry. Plug in.
shredding
3
* Apply oil Set to Reverse (R)
2-3 seconds
across entry
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Make sure head is on basket correctly
Wait 20 minutes for motor to cool down
Remove and empty basket
Make sure safety lock is in unlock
position
3